ZG3Cr13钢经长期时效后组织及硬度的研究

研究了ZG3Cr13钢在550℃～600℃的工作温度区间经2500h长期时效后的硬度及组织的变化。结果表明，在时效1000h内，硬度有明显的下降，之后趋于稳定；组织变化与正常处理后的组织均匀化程度有关，原始组织越均匀组织稳定性和热强性越高。     

桥用高性能混凝土的徐变与应用

基于2座桥梁混凝土徐变的试验结果，论述了高性能混凝土的长期变形特征，指出对提高混凝土弹性模量、减少徐变收缩的水泥、外加剂和骨料的三要素中，骨料的作用最明显．提出了徐变的湿度、尺寸修正方法与计算式，探讨了掺筋混凝土的徐变修正、徐变行为的温度效应及长期徐变等．     

Creep of aromatic polyamide fibres

Creep of Kevlar 29, Kevlar 49 and PRD 49-III fibres was investigated. The fibres exhibited transient creep and the strain-time relationship was represented by a logarithmic time law. The creep strain recovered with time when the load was removed. Upon reloading to the same creep stress the strain-time relationship was again logarithmic but the creep rate was reduced. Modulus measurements were made during the creep test and these showed that the modulus increased with time. This result indicated a crystallite rotation mechanism which could account for the experimentally observed creep strain. Creep in PRD 49-III fibres exhibited a small temperature dependence over the temperature range 20°C to 150°C. The apparent creep activation energy was consistent with the range of values reported for hydrogen bonding. This suggests one possible creep mechanism in which the combined action of stress and thermal activation causes rearrangement of intercrystalline bonds in the crystallite boundaries resulting in boundary creep. Boundary creep allows crystallite rotation which produces the macroscopic creep strain. Boundary creep is discussed in terms of the fibre morphology and a model of delayed elasticity.     

杜84断块超稠油开发中后期稳产对策研究

对杜84断块超稠油生产中后期暴露的主要矛盾，即随着轮次升高，周期吞吐效果变差，井下技术状况日益变差。油层动用不均，汽窜加剧等问题进行了分析。并提出了相应的稳产对策-实施多井整体吞吐，大修复产，调剖等措施。现场应用证明，这些措施基本能够确保杜84断块超稠油中后期的稳产。     

两种型面轮轨滚动接触蠕滑率/力的比较

本文从数值方面详细分析了两种型面轮对和轨道在滚动接触过程的接触几何、蠕滑率和蠕滑力。在利用Kalker三维弹性体非赫兹滚动接触理论进行轮轨蠕滑力分析时，首先利用有限元方法确定了因轮轨的弹性变形而引起轮轨接触点处的弹性位移差。并利用弹性位移差修正Kalker理论中由Boussinesq和Cerruti公式确定的力和位移的影响系数，使本文的数值过程能考虑到轮轨结构变形对轮轨接触斑的影响。通过计算分析可知，在轮对运动状态相同的情况下，磨耗型轮对和轨道之间的力学行为与锥型轮对和轨道之间的力学行为相比，存在较大差异。数值结果有助于进一步分析轮轨之间的磨耗、滚动接触疲劳和轮轨使用寿命，为采取相应措施提供理论依据。同时发现目前我国铁路所采用的1/40轨底坡与目前正在全面推广使用的磨耗型轮对不是处于最佳匹配状态，有待进一步改进。     

凝析气藏物质平衡方程的改进与应用

为了提高凝析气藏油气采收率，通常采用目前最有效的循环注气保持地层压力的开采方式。在此开采方式下，直接采用气藏物质平衡方程进行地质储量计算将出现很大偏差。针对这种情况，将气藏物质平衡方程进行了改进，得到凝析气藏在注气开发方式下的物质平衡方程。     

Electrochemistry of polyaniline: Study of the pH effect and electrochromism

Polyaniline was electrochemically synthesized from an aqueous medium with various acid electrolytes via potentiodynamic and potentiostatic techniques. The electrochemical synthesis of polyaniline was studied over various substrates, including Pt, Ti, Ni, and SnO₂ coated glass, and in various acid electrolytes. Cyclic voltammograms of electrochemically synthesized polyaniline were studied in HCl in a pH range of 1–4. Probable electrochemistry and chemical changes were deduced that occurred when polyaniline film was electrochemically oxidized and reduced between ?0.2 and 1.0 V versus a Ag/AgCl reference electrode in an acidic electrolyte at pH 1, and three corresponding oxidation and reduction peaks were described instead of two redox peaks (as observed by W. S. Huang, B. D. Humphrey, and A. G. MacDiarmid, J Chem Soc Faraday Trans 1 1986, 82, 2385). The electrochromic property was studied with changes in the chemical states of polyaniline during electrochemical oxidation and reduction. A new viscous electrolyte, aqueous AlCl₃ (pH 2), saturated with AgCl was used for the construction of an electrochromic display device. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 83: 378–385, 2002     

Development of ultra light magnesium-lithium alloys

Magnesium-lithium alloys are among the lowest density metallic materials. Addition of lithium, with a relative density of 0·53, in magnesium reduces the density of the alloy significantly. Furthermore, addition of nearly 11 wt.% lithium converts hexagonal close packed structure of pure magnesium to a body centered cubic lattice, markedly improving formability of the alloy. The development of these alloys, however, had been hampered due to the high reactivity of lithium and magnesium in the molten state and also, due to poor creep resistance and instability of mechanical properties at room temperature. In an attempt to indigenize these ultra light alloys for possible applications in Indian satellite programme, detailed research work was initiated in DMRL. The difficulties associated with producing sound cast ingots have been overcome by controlling melting and casting parameters of these alloys. Extensive work has been done on structure-property correlation of alloys with varying lithium content and minor alloying additions. Based on these work, advanced magnesium-lithium alloys have been developed with improved tensile properties, room temperature stability and creep resistance. Wrought products (plates/sheets) of magnesium-lithium alloy have been supplied to ISAC, Bangalore and are being used in their INSAT-2 programme. This paper describes the systematic studies carried out in the laboratory to indigenize these ultra light alloys.     

évaluation du livre intitulé manuel de gérontologie sociale 2.

Reviews the book, Manuel de gérontologie sociiale 2 by Jean Carette (1992). The Handbook of Social Gerontology 2 constitutes a practical complement of volume 1 which related to the social aspects of ageing and the retirement. Volume 2 relates mainly to the social intervention whose objective is to support the action and the collective mobilization individuals and associations of retirements. Using a 30-year experiment with groups of retirees, either in preparation of retirement, or in the collective action, the author approaches a new ground in gerontology. He proposes a new approach--social gerontology, (PsycINFO Database Record (c) 2010 APA, all rights reserved)